KNOWN FAULTS · Toyota

Toyota Proace City 1.2 Turbo common problems.

2019–2026 · Petrol

Sources are not verified in real time and no entry confirms that your car is affected.

2 known faults with sources

Applies if: The 1.2 Turbo is the PSA 1.2 PureTech.

Oil-bath timing belt degradationTiming / lubrication

Engine / equipment: 1.0 / 1.2 PureTech (EB2) in the Peugeot 208/2008/308/3008/5008, Citroën C3/C4/C5 Aircross, DS 3, Opel Corsa/Crossland/Grandland
Period mentioned: 2012 – approx. 2022
Symptoms: Oil pressure warning, hard brake pedal or reduced assistance, oil consumption, blue smoke, squeal at the front of the engine, turbo whistles or loses power.
Possible cause described: The timing belt runs in oil and degrades (especially with short trips and fuel dilution). Debris clogs the oil pump strainer, the brake vacuum pump filter, the turbo oil feed and the variable valve timing solenoids. Stellantis announced compensation for affected owners in 2025.
Check for the garage: Measure the belt through the oil filler opening with the manufacturer's tool. Confirm whether the vacuum pump campaign was done.
Cost cited in the source: Vacuum pump: €500–800; belt with oil system cleaning: considerably moreA rough figure from the original database, not an up-to-date quote.

Applies if: Toyota USA tech tip for all its models: it applies if the judder began after wheels, pads or discs were removed or changed.

Brake judder from wheel nuts over-tightened or tightened unevenly (Toyota tech tip)Brakes

Engine / equipment: Any Toyota: it depends on how the wheels are tightened
Period mentioned: 2016 tech tip for all its models
Symptoms: Vibration in the steering wheel and the pedal when braking, even gently and at any speed, often shortly after wheels, pads or discs were changed.
Possible cause described: Toyota points out in a tech tip that if the wheel nuts are over-tightened or tightened unevenly (a single one is enough), the brake disc is left with runout and brake judder appears. It happens above all when they are run fully home with an impact gun instead of a torque wrench in a star pattern.
Check for the garage: Ask the garage to loosen and re-tighten the nuts with a torque wrench, to the manual's torque and in a star pattern, and to measure whether the discs have been left warped; if so, they will need skimming or replacing.
Cost cited in the source: No verified estimate; ask the garage for a quote.A rough figure from the original database, not an up-to-date quote.