KNOWN FAULTS · Toyota

Toyota Proace (I) common problems.

2013–2016 · Diesel

Sources are not verified in real time and no entry confirms that your car is affected.

3 known faults with sources

Engines: 1.6 / 2.0 HDi (Diesel)

Applies if: Only the 1.6 HDi: the Proace uses the PSA DV6 engine.

Turbo oil starvation from injector carbonTurbo / injection

Engine / equipment: 1.6 HDi DV6 (Peugeot 207/308/3008/Partner, Citroën C3/C4/Berlingo; same engine as the Ford 1.6 TDCi)
Period mentioned: Approx. 2004–2015
Symptoms: Loud turbo whistle, power loss, blue or black smoke, oil that gets dirty very quickly. Before the failure, often a puffing or ticking from the cylinder head and an exhaust smell from an injector.
Possible cause described: The injector clamp bolts work loose, the gas leak forms carbon that gets into the oil and clogs the mesh filter in the banjo bolt feeding the turbo. The turbo is starved of oil. Replacing only the turbo does not fix it.
Check for the garage: Check injector bolt torque and carbon at their base, the turbo banjo bolt and the sump strainer.
Cost cited in the source: Turbo + full oil system cleaning: approx. €900–2,000 (estimate)A rough figure from the original database, not an up-to-date quote.

Engines: 1.6 / 2.0 HDi (Diesel)

Applies if: Only the 2.0 HDi: the Proace uses the PSA DW10 engine.

2.0/2.2 HDi DPF, EGR, turbo and flywheelDPF / EGR / turbo / flywheel

Engine / equipment: PSA 2.0 HDi (DW10) and 2.2 HDi (DW12), including the 2.0/2.2 JTD in the Fiat Ulysse and Scudo and the Lancia Phedra
Period mentioned: 1998–2015
Symptoms: Particulate filter warning and power loss; rough idle from a dirty EGR; vibration and knocks when starting or in low gears (dual-mass flywheel); smoke or hesitation from injectors at high mileage.
Possible cause described: The engine itself is very robust, but the ancillaries are not: the DPF with Eolys additive clogs in town use, the EGR and its cooler fill with soot, the variable-geometry turbo sticks and the dual-mass flywheel wears. The 136 hp versions have more problems than the 138 to 163 hp ones.
Check for the garage: Read the DPF status and additive level, check the EGR and cooler, check the dual-mass flywheel at start-up and measure injector balance rates.
Cost cited in the source: Forced DPF regeneration: €100–150; new DPF: €800–1,500; rebuilt injector: €200–250A rough figure from the original database, not an up-to-date quote.

Mileage cited in the database: 120,000–180,000 km. This is not a maintenance interval and does not predict a failure.

Engines: 1.6 / 2.0 HDi (Diesel)

Applies if: Toyota USA tech tip for all its models: it applies if the judder began after wheels, pads or discs were removed or changed.

Brake judder from wheel nuts over-tightened or tightened unevenly (Toyota tech tip)Brakes

Engine / equipment: Any Toyota: it depends on how the wheels are tightened
Period mentioned: 2016 tech tip for all its models
Symptoms: Vibration in the steering wheel and the pedal when braking, even gently and at any speed, often shortly after wheels, pads or discs were changed.
Possible cause described: Toyota points out in a tech tip that if the wheel nuts are over-tightened or tightened unevenly (a single one is enough), the brake disc is left with runout and brake judder appears. It happens above all when they are run fully home with an impact gun instead of a torque wrench in a star pattern.
Check for the garage: Ask the garage to loosen and re-tighten the nuts with a torque wrench, to the manual's torque and in a star pattern, and to measure whether the discs have been left warped; if so, they will need skimming or replacing.
Cost cited in the source: No verified estimate; ask the garage for a quote.A rough figure from the original database, not an up-to-date quote.