Skip to content
Emergency
KNOWN FAULTS · Audi

Known faults for the Audi A1 (8X).

2010–2018 · Petrol / Diesel

Sources are not verified in real time and no entry confirms that your car is affected.

Buying it used?Which engine has the fewest documented faults, which recalls to ask the seller about and what to look for on the test drive.Before you buy

6 known faults with sources

Engines: 1.2 TFSI (EA111) (Petrol) · 1.4 TFSI (EA111, hasta 2014) (Petrol) · 1.0 / 1.4 TFSI (EA211, desde 2014) (Petrol) · 1.6 TDI (Diesel)

Applies if: Only if fitted with the 7-speed DQ200 DSG. Confirm the gearbox type.

DSG7 gearbox mechatronic unit (DQ200)Gearbox
Engine / equipment
7-speed DQ200 DSG gearbox (dry clutch, 0AM mechatronics), paired with 1.0/1.2/1.4 TSI and 1.6 TDI engines
Period mentioned
2008 onwards
Symptoms
Judder or shudder pulling away in 1st/2nd, reverse won't engage, PRNDS letters flashing or a spanner warning, gearbox stuck in one gear (limp mode).
Possible cause described
Mechatronic unit failure: the pressure accumulator develops fatigue cracks, the electric pump runs constantly and the gearbox loses pressure. The mechatronic's 30 A fuse sometimes blows. Wear of the dry dual clutch is also common.
Check for the garage
Read the gearbox module faults with VCDS, OBDeleven or similar and check the mechatronic fuse.
Cost cited in the source
€350–550 to repair the mechatronic unit alone; €1,000–1,200 including removal and refittingA rough figure from the original database, not an up-to-date quote.

Sources from the original database

View full entry

Engines: 1.2 TFSI (EA111) (Petrol) · 1.4 TFSI (EA111, hasta 2014) (Petrol)

EA111 TSI chain and tensionerTiming system
Engine / equipment
1.2 / 1.4 TSI-TFSI EA111 (Polo, Golf V/VI, Ibiza, Fabia, Octavia, Audi A1, Yeti, Touran…)
Period mentioned
2006–2014
Symptoms
Rattle on a cold start, engine light for timing deviation; if the chain jumps, the engine cranks but won't start.
Possible cause described
A narrow chain and a hydraulic tensioner that loses pressure: the chain stretches, often between 60,000 and 100,000 km. VW revised the chain, guides, tensioner and camshaft.
Check for the garage
Listen to a cold start and read the timing deviation values with VCDS. Ask for an invoice showing the revised kit was fitted.
Cost cited in the source
€800–1,500A rough figure from the original database, not an up-to-date quote.

Mileage cited in the database: 60,000–100,000 km. This is not a maintenance interval and does not predict a failure.

Sources from the original database

View full entry

Engines: 1.2 TFSI (EA111) (Petrol) · 1.4 TFSI (EA111, hasta 2014) (Petrol) · 1.0 / 1.4 TFSI (EA211, desde 2014) (Petrol) · 1.6 TDI (Diesel) · S1 (2.0 TFSI) (Petrol)

Applies if: Only if fitted with the air conditioning system described.

A/C not cooling: N280 valveClimate control
Engine / equipment
Air conditioning with clutchless compressor and N280 regulating valve (combustion VW, Audi, Seat, Cupra and Skoda from 2006)
Period mentioned
2006–2026
Symptoms
The air does not cool or cools intermittently (for example only at motorway speed), and sometimes the compressor rattles with the A/C on. Codes 01232 (N280 valve), P2612 or 00898.
Possible cause described
The compressor regulates its output with the N280 solenoid valve, its most common failure point. Audi issued technical bulletins over a manufacturing fault in this valve on Sanden compressors. Its connector can also become brittle and corrode (especially without the engine undertray), or the wiring fails.
Check for the garage
Read the codes and N280 control current with VCDS or ODIS, measure its resistance (about 10 ohms) and check the connector and wiring before replacing parts. If the valve or compressor is replaced, the whole circuit must be flushed.
Cost cited in the source
N280 valve: a cheap part (about 30 dollars) where sold separately; new compressor with circuit flush: considerably moreA rough figure from the original database, not an up-to-date quote.

Sources from the original database

View full entry

Engines: 1.0 / 1.4 TFSI (EA211, desde 2014) (Petrol)

Applies if: Only EA211 1.0, 1.2 and 1.4 TSI/TFSI engines; the 1.5 TSI evo is not documented in this record's sources.

Water pump and thermostat housing leaks (EA211)Cooling
Engine / equipment
EA211 1.0, 1.2 and 1.4 TSI/TFSI petrol (Golf VII, Polo, Octavia III, Leon 5F, A3 8V, Ibiza, Fabia III and other MQB cars)
Period mentioned
2012–2020
Symptoms
Coolant level drops slowly with no visible puddle, dried white or pink residue behind the engine, a sweet smell and a low-level warning. If loss continues, it can overheat.
Possible cause described
The water pump is built into a plastic housing with the thermostats, which warps and cracks with heat cycles, and its seals degrade. A trade magazine also notes that oil from a nearby leak (for example the crankcase ventilation) speeds up failure of the housing and the pump belt.
Check for the garage
With the engine cold, monitor the level for several days and look for dried residue around the housing and the coolant pipe under the air box. At a garage: pressure test and check for nearby oil leaks. Replacing pump and housing as one assembly is recommended; do not use stop-leak products. Never open the system hot.
Cost cited in the source
A reliability guide quotes €500–1,000 for the 1.4 TSI and €300–600 for the 1.2 TSI.A rough figure from the original database, not an up-to-date quote.

Sources from the original database

View full entry

Engines: 1.6 TDI (Diesel)

Cracked EGR coolerCooling / EGR
Engine / equipment
1.6 and 2.0 TDI (EA189 and EA288)
Period mentioned
Approx. 2010–2020
Symptoms
Coolant level drops with no visible leak, white smoke with a sweet smell, rising temperature or engine light. In severe cases the engine hydrolocks.
Possible cause described
The internal tubes of the EGR cooler crack and coolant enters the intake. It worsened after the post-Dieselgate software update, which increased EGR use.
Check for the garage
Cooling system pressure test and check for coolant in the intake or manifold.
Cost cited in the source
€400–1,300A rough figure from the original database, not an up-to-date quote.

Sources from the original database

View full entry

Engines: S1 (2.0 TFSI) (Petrol)

Applies if: Only Audi S1 2.0 TFSI MY2014–2018 with Haldex Gen 5 and controller 0AY907554F physically confirmed; symptoms and testing confirm an ECU fault, after ruling out the pump, power supply and network.

Haldex 5 without communication or all-wheel driveDrivetrain / electronics
Engine / equipment
S1: Haldex 5 controller, reference 0AY907554F
Period mentioned
Only production periods and VINs documented in the application conditions.
Symptoms
Traction warning, absent AWD function and no communication.
Possible cause described
Controller failure confirmed through testing; no single internal mechanism published.
Check for the garage
Confirm reference; check pump, power and network before testing and repairing controller.
Cost cited in the source
No verified quote; confirm part and diagnosis.A rough figure from the original database, not an up-to-date quote.

Sources from the original database

View full entry

Engines for this model