KNOWN FAULTS · Audi

Known faults for the Audi R8 (42).

2007–2015 · Petrol

Sources are not verified in real time and no entry confirms that your car is affected.

3 known faults with sources

Engines: 4.2 FSI V8 (Petrol)

4.2 V8 rear chains and carbon build-upTiming / intake

Engine / equipment: 4.2 V8 40-valve (S4 B6/B7) and 4.2 FSI V8 (RS4 B7, S5 8T until 2011, RS5, R8, Q7 4L)
Period mentioned: 2003–2015
Symptoms: Rattle from the rear of the engine on a cold start, misfires or an engine light for timing deviation; on FSI engines, power loss and rough idle from carbon build-up.
Possible cause described: The timing chains sit at the rear of the engine, against the bulkhead, with plastic guides and tensioners that crack; replacing them means removing the engine. FSI direct injection builds carbon on the intake valves from about 40,000–60,000 km.
Check for the garage: Listen to a cold start, read crank-cam correlation codes and inspect the intake valves with a borescope.
Cost cited in the source: Chains (engine out): approx. €6,500–11,000 on a Q7 4.2 FSI (converted from dollars); carbon cleaning: far lessA rough figure from the original database, not an up-to-date quote.

Mileage cited in the database: from 40,000 km. This is not a maintenance interval and does not predict a failure.

Engines: 4.2 FSI V8 (Petrol) · 5.2 FSI V10 (Petrol)

Applies if: Only if fitted with the air conditioning system described.

A/C not cooling: N280 valveClimate control

Engine / equipment: Air conditioning with clutchless compressor and N280 regulating valve (combustion VW, Audi, Seat, Cupra and Skoda from 2006)
Period mentioned: 2006–2026
Symptoms: The air does not cool or cools intermittently (for example only at motorway speed), and sometimes the compressor rattles with the A/C on. Codes 01232 (N280 valve), P2612 or 00898.
Possible cause described: The compressor regulates its output with the N280 solenoid valve, its most common failure point. Audi issued technical bulletins over a manufacturing fault in this valve on Sanden compressors. Its connector can also become brittle and corrode (especially without the engine undertray), or the wiring fails.
Check for the garage: Read the codes and N280 control current with VCDS or ODIS, measure its resistance (about 10 ohms) and check the connector and wiring before replacing parts. If the valve or compressor is replaced, the whole circuit must be flushed.
Cost cited in the source: N280 valve: a cheap part (about 30 dollars) where sold separately; new compressor with circuit flush: considerably moreA rough figure from the original database, not an up-to-date quote.

Engines: 5.2 FSI V10 (Petrol)

Applies if: United States; R8 5.2 FSI model year 2014; symptom P218100 and diagnosis included in TSB 2036114/1.

R8 thermostat and P218100 warningCooling

Engine / equipment: MY2014 R8 5.2 FSI thermostat F265
Period mentioned: Only production periods and VINs documented in the application conditions.
Symptoms: Engine warning lamp and P218100 code.
Possible cause described: Measured temperature fails to reach the mapped value; the bulletin prescribes thermostat replacement.
Check for the garage: Follow bulletin diagnosis; replace F265 and refill coolant to official specification.
Cost cited in the source: No verified estimate; check applicable warranty and quotation.A rough figure from the original database, not an up-to-date quote.