KNOWN FAULTS · Opel

Opel Zafira Tourer C 1.4 / 1.6 Turbo common problems.

2011–2019 · Petrol

Sources are not verified in real time and no entry confirms that your car is affected.

2 known faults with sources

Opel 1.4 Turbo timing chainValve timing

Engine / equipment: 1.4 Turbo A14NET (Astra J, Meriva B, Mokka, Zafira C, Cascada…)
Period mentioned: 2009–2018
Symptoms: Chain rattle, engine light and lack of power. Note: a rattle lasting only 1–3 seconds on a cold start is usually the dual-mass flywheel, not the chain.
Possible cause described: The timing chain on the 1.4 Turbo stretches, a different problem from the naturally aspirated 1.2 and 1.4.
Check for the garage: Listen to how long the noise lasts on a cold start and check chain stretch with a diagnostic tool before replacing it.
Cost cited in the source: Chain: approx. €820–3,700 (converted from dollars)A rough figure from the original database, not an up-to-date quote.

Applies if: Only if fitted with the M32 six-speed manual (common on six-speed turbo and diesel versions); confirm by VIN.

M32 manual gearbox bearingsGearbox

Engine / equipment: Getrag M32 six-speed manual: Opel Astra H and J, Insignia A, Zafira B and C, Vectra C, Meriva B, Cascada, Corsa OPC and some Fiats with the T-Jet engine
Period mentioned: 2004–2019
Symptoms: A whine that rises with speed, mainly in 5th and 6th (also in 1st and 2nd), a loose gear lever that moves on and off the throttle and, when advanced, gears jumping out. Left unrepaired, the bearing can break through the casing.
Possible cause described: The bearings wear, mainly the shaft bearing next to 6th gear: the rollers develop play and the shaft moves under load, which reaches the lever. A specialist blames incorrect factory shimming. Second-generation boxes with the revised end case fail far less, according to an Australian repairer.
Check for the garage: In a garage test: confirm whether the noise depends on road speed (wheel bearing, tyre) or the gear engaged (gearbox), and whether the lever moves under load. Check the oil for metal debris. Repair early: replacing all bearings and fitting the revised end case costs far less than a new gearbox.
Cost cited in the source: One owner replaced only the main bearing for about £47 in parts versus about £1,000 for a rebuilt gearbox; another quotes about €600 at a specialist.A rough figure from the original database, not an up-to-date quote.