KNOWN FAULTS · Peugeot

Peugeot 508 (II) 2.0 BlueHDi common problems.

2018–2026 · Diesel

Sources are not verified in real time and no entry confirms that your car is affected.

2 known faults with sources

AdBlue system failure (start countdown)Exhaust and emissions (AdBlue)

Engine / equipment: 1.5 / 1.6 / 2.0 BlueHDi with AdBlue (Peugeot, Citroën, DS, Opel)
Period mentioned: Approx. 2014 onwards
Symptoms: Emission system fault message and a “starting impossible in X km” countdown, AdBlue/UREA warning and engine light.
Possible cause described: Failure of the AdBlue tank pump module (circuit board, pressure sensor or heater) or of the AdBlue injector. The engine does not stop while driving, but once the countdown reaches zero it will not restart.
Check for the garage: Diagnose with Diagbox or equivalent: AdBlue pressure, flow test and tank temperature.
Cost cited in the source: Complete module or tank: approx. €600–1,500 (estimate)A rough figure from the original database, not an up-to-date quote.

Applies if: Only if fitted with the automatic gearbox described in the record.

EAT6/EAT8 jerking and torque converterAutomatic gearbox

Engine / equipment: Aisin EAT6 and EAT8 automatic gearboxes (308, 3008, 5008, 508, 2008, C4 Picasso, C5 Aircross, C4, DS 7, Grandland…)
Period mentioned: 2013–2026
Symptoms: Hesitation or a jolt between 1st and 2nd, torque converter shudder in traffic, harsh or delayed shifts and a gearbox fault warning, especially on 2017–2019 3008s.
Possible cause described: Torque converter wear or drift, valve deposits from degraded oil and software faults. Peugeot treats the oil as lifetime, but dirty or low oil causes harsh shifts.
Check for the garage: Check oil level and condition, update the gearbox software at the dealer and, after an oil change, record it with DiagBox and reset the adaptations.
Cost cited in the source: Oil change and update: the most common fix; torque converter or valve body: specialist garage repairA rough figure from the original database, not an up-to-date quote.