KNOWN FAULTS · Smart

Smart fortwo / forfour (453) 0.9 / 1.0 (Renault) common problems.

2014–2024 · Petrol

Sources are not verified in real time and no entry confirms that your car is affected.

3 known faults with sources

Single clunk from the rear drive shaft when moving off or changing direction (smart and Mercedes-Benz)Transmission

Engine / equipment: smart fortwo and forfour 453 and Mercedes-Benz cars with rear drive shafts
Period mentioned: 2014 onwards
Symptoms: A single sharp clunk at a rear wheel when moving off or switching from reverse to forward (or the other way round); it makes no noise while driving.
Possible cause described: Micro-movement or a cracked micro-weld between the wheel bearing inner race and the drive shaft's outer joint housing. Mercedes-Benz technical note LI35.30-P-058566 fixes it by coating that contact surface with Molykote paint.
Check for the garage: Tell the garage it is a single clunk when changing direction; the technical note says to test by loosening the drive shaft nut by one turn (it is always replaced with a new one).
Cost cited in the source: No verified estimate; ask the garage for a quote.A rough figure from the original database, not an up-to-date quote.

Applies if: Weak points of this model from inspections, breakdown statistics and recalls; anything specific to one engine is stated in the sheet.

12 V battery, brakes and campaigns on the smart 453 (EQ too)Known weak points

Engine / equipment: smart fortwo and forfour 453 (petrol and electric EQ)
Period mentioned: 2014–2024
Symptoms: A flat 12 V battery on 2015–2016 cars (no lights-on warning); at inspection, suspension, rusting brakes and lights (and on petrols, oil leaks and a rusty exhaust); electronic faults (radio, a pedal sensor that upsets the stop-start); on the forfour, an emergency-call assistant that does not work.
Possible cause described: CarWiki rates the technology as very reliable. Recalls (KBA): the link between the P selector cable and the gearbox, a handbrake cable nut that could come loose and front steering knuckles that could break due to a manufacturing fault.
Check for the garage: Test the 12 V battery; brake hard now and then (especially on the EQ); check campaigns by VIN.
Cost cited in the source: No verified estimate; ask the garage for a quote.A rough figure from the original database, not an up-to-date quote.

Applies if: Only the 0.9 turbo (Renault H4Bt); the naturally aspirated 1.0 is a different engine.

Stretched timing chain on the 0.9 and 1.2 TCeValve timing

Engine / equipment: 0.9 TCe (H4Bt) and 1.2 TCe (H5Ft) turbo petrol
Period mentioned: Approx. 2012–2020
Symptoms: Metallic chain rattle, especially when cold or at idle; engine light with a crankshaft–camshaft correlation code; in serious cases the chain jumps and damages the valves.
Possible cause described: The chain, meant to last the engine’s life, can stretch early; tensioners and plastic guides wear, and very long oil-change intervals speed up the wear.
Check for the garage: With any chain noise or a P0016 code, diagnose straight away: measure the stretch and check the tensioner and guides before the timing jumps. Shorten oil-change intervals.
Cost cited in the source: No verified estimate; ask the garage for a quote for the chain kit.A rough figure from the original database, not an up-to-date quote.