Known faults for the Volkswagen Scirocco III.
2008–2017 · Petrol / Diesel
Sources are not verified in real time and no entry confirms that your car is affected.
7 known faults with sources
Engines: 1.4 TSI (EA111) (Petrol)
Applies if: Only if fitted with the 7-speed DQ200 DSG. Confirm the gearbox type.
DSG7 gearbox mechatronic unit (DQ200)Gearbox
- Engine / equipment
- 7-speed DQ200 DSG gearbox (dry clutch, 0AM mechatronics), paired with 1.0/1.2/1.4 TSI and 1.6 TDI engines
- Period mentioned
- 2008 onwards
- Symptoms
- Judder or shudder pulling away in 1st/2nd, reverse won't engage, PRNDS letters flashing or a spanner warning, gearbox stuck in one gear (limp mode).
- Possible cause described
- Mechatronic unit failure: the pressure accumulator develops fatigue cracks, the electric pump runs constantly and the gearbox loses pressure. The mechatronic's 30 A fuse sometimes blows. Wear of the dry dual clutch is also common.
- Check for the garage
- Read the gearbox module faults with VCDS, OBDeleven or similar and check the mechatronic fuse.
- Cost cited in the source
- €350–550 to repair the mechatronic unit alone; €1,000–1,200 including removal and refittingA rough figure from the original database, not an up-to-date quote.
Sources from the original database
Engines: 1.4 TSI (EA111) (Petrol)
EA111 TSI chain and tensionerTiming system
- Engine / equipment
- 1.2 / 1.4 TSI-TFSI EA111 (Polo, Golf V/VI, Ibiza, Fabia, Octavia, Audi A1, Yeti, Touran…)
- Period mentioned
- 2006–2014
- Symptoms
- Rattle on a cold start, engine light for timing deviation; if the chain jumps, the engine cranks but won't start.
- Possible cause described
- A narrow chain and a hydraulic tensioner that loses pressure: the chain stretches, often between 60,000 and 100,000 km. VW revised the chain, guides, tensioner and camshaft.
- Check for the garage
- Listen to a cold start and read the timing deviation values with VCDS. Ask for an invoice showing the revised kit was fitted.
- Cost cited in the source
- €800–1,500A rough figure from the original database, not an up-to-date quote.
Mileage cited in the database: 60,000–100,000 km. This is not a maintenance interval and does not predict a failure.
Sources from the original database
Engines: 1.4 TSI (EA111) (Petrol) · 2.0 TSI (EA888) (Petrol) · 2.0 TDI (Diesel)
Applies if: Only if fitted with the air conditioning system described.
A/C not cooling: N280 valveClimate control
- Engine / equipment
- Air conditioning with clutchless compressor and N280 regulating valve (combustion VW, Audi, Seat, Cupra and Skoda from 2006)
- Period mentioned
- 2006–2026
- Symptoms
- The air does not cool or cools intermittently (for example only at motorway speed), and sometimes the compressor rattles with the A/C on. Codes 01232 (N280 valve), P2612 or 00898.
- Possible cause described
- The compressor regulates its output with the N280 solenoid valve, its most common failure point. Audi issued technical bulletins over a manufacturing fault in this valve on Sanden compressors. Its connector can also become brittle and corrode (especially without the engine undertray), or the wiring fails.
- Check for the garage
- Read the codes and N280 control current with VCDS or ODIS, measure its resistance (about 10 ohms) and check the connector and wiring before replacing parts. If the valve or compressor is replaced, the whole circuit must be flushed.
- Cost cited in the source
- N280 valve: a cheap part (about 30 dollars) where sold separately; new compressor with circuit flush: considerably moreA rough figure from the original database, not an up-to-date quote.
Sources from the original database
Engines: 2.0 TSI (EA888) (Petrol)
Excessive oil consumption (piston rings)Engine
- Engine / equipment
- 1.8 / 2.0 TSI-TFSI EA888, 2nd generation
- Period mentioned
- Approx. 2009–2015
- Symptoms
- Very high oil consumption (over 1 litre per 1,000 km), low oil warning, bluish smoke, oil-fouled spark plugs.
- Possible cause described
- Piston rings that are too thin carbon up and lose tension, letting oil into the combustion chamber. The crankcase ventilation (PCV) valve can also contribute.
- Check for the garage
- Controlled oil consumption test over 1,000 km, compression or leak-down test and a PCV valve check.
- Cost cited in the source
- €3,000–5,000 (new pistons and rings)A rough figure from the original database, not an up-to-date quote.
Sources from the original database
Engines: 2.0 TSI (EA888) (Petrol)
Timing chain tensionerTiming system
- Engine / equipment
- 1.8 / 2.0 TSI-TFSI EA888, 1st and 2nd generation
- Period mentioned
- Approx. 2008–2015
- Symptoms
- Metallic rattle for a few seconds on a cold start, engine light for camshaft/crankshaft correlation; in the worst case the engine won't start after a loud noise.
- Possible cause described
- The hydraulic chain tensioner (old design) loses pressure on cold starts, the chain goes slack and can jump teeth, causing valves to hit pistons.
- Check for the garage
- An inspection plug on the lower timing cover shows the tensioner position. Listen to a cold start.
- Cost cited in the source
- €1,500–4,000 (chain, guides and tensioner)A rough figure from the original database, not an up-to-date quote.
Sources from the original database
View full entryEngines: 2.0 TSI (EA888) (Petrol) · 2.0 TDI (Diesel)
Applies if: Only if fitted with the 6-speed DQ250 DSG. Confirm the gearbox type.
DQ250 DSG mechatronic and oilDSG gearbox
- Engine / equipment
- DQ250 6-speed wet-clutch DSG (2.0 TDI, 2.0 TSI and other powerful engines in the Golf, Passat, Tiguan, A3, TT, Octavia, Superb, Leon…)
- Period mentioned
- 2003–2020
- Symptoms
- Jerking or shudder when pulling away and at low speed, harsh shifts, gearbox warning or limp mode; codes P17BF, P189C, P0841, P0871 or P0717.
- Possible cause described
- In most cases the cause is the mechatronic unit (the electro-hydraulic control unit), not the clutches. The oil shares a circuit with the clutches and degrades, carrying debris that damages the valves; the pan can also rust and leak. Volkswagen specifies an oil and filter change every 60,000 km.
- Check for the garage
- Read codes with ODIS or VCDS, check the oil change history, inspect the pan for rust or leaks and the clutch adaptation values. Replacing the mechatronic control board is often enough.
- Cost cited in the source
- Oil and filter change: maintenance every 60,000 km; control board or mechatronic: expensive repairA rough figure from the original database, not an up-to-date quote.
Mileage cited in the database: from 60,000 km. This is not a maintenance interval and does not predict a failure.
Sources from the original database
Engines: 2.0 TDI (Diesel)
Cracked EGR coolerCooling / EGR
- Engine / equipment
- 1.6 and 2.0 TDI (EA189 and EA288)
- Period mentioned
- Approx. 2010–2020
- Symptoms
- Coolant level drops with no visible leak, white smoke with a sweet smell, rising temperature or engine light. In severe cases the engine hydrolocks.
- Possible cause described
- The internal tubes of the EGR cooler crack and coolant enters the intake. It worsened after the post-Dieselgate software update, which increased EGR use.
- Check for the garage
- Cooling system pressure test and check for coolant in the intake or manifold.
- Cost cited in the source
- €400–1,300A rough figure from the original database, not an up-to-date quote.
Sources from the original database
View full entryEngines for this model
- 1.4 TSI (EA111)Petrol
- 2.0 TSI (EA888)Petrol
- 2.0 TDIDiesel