KNOWN FAULTS · Audi

Audi Q5 (8R) 3.0 TDI V6 common problems.

2008–2017 · Diesel

Sources are not verified in real time and no entry confirms that your car is affected.

3 known faults with sources

V6 TDI rear chains, intake flaps and leaksTiming / intake / leaks

Engine / equipment: 2.7 and 3.0 TDI V6 (EA896 and EA897): Audi A4, A5, A6, A7, A8, Q5, Q7; VW Touareg, Phaeton and Amarok; Porsche Cayenne, Macan and Panamera
Period mentioned: 2004–2018
Symptoms: Chain rattle for the first seconds after a cold start; power loss or limp mode from the intake flaps; coolant or oil loss in the engine V; EGR faults with rough idle.
Possible cause described: The timing chains sit at the rear of the engine, against the bulkhead, and their tensioners lose pressure. The intake flaps use plastic linkage rods that wear. The coolant valve, oil cooler gasket and EGR are packed into the engine V and leak with age.
Check for the garage: Listen to a cold start (a rattle lasting more than 2–3 seconds is a bad sign), check flap operation with a diagnostic tool, look for leaks in the engine V and check the oil change history.
Cost cited in the source: Tensioners and chains: approx. €2,000–4,500; EGR with cooler: €1,000–1,500; oil cooler gasket: €300–600A rough figure from the original database, not an up-to-date quote.

Mileage cited in the database: 100,000–150,000 km. This is not a maintenance interval and does not predict a failure.

Applies if: Only if fitted with the air conditioning system described.

A/C not cooling: N280 valveClimate control

Engine / equipment: Air conditioning with clutchless compressor and N280 regulating valve (combustion VW, Audi, Seat, Cupra and Skoda from 2006)
Period mentioned: 2006–2026
Symptoms: The air does not cool or cools intermittently (for example only at motorway speed), and sometimes the compressor rattles with the A/C on. Codes 01232 (N280 valve), P2612 or 00898.
Possible cause described: The compressor regulates its output with the N280 solenoid valve, its most common failure point. Audi issued technical bulletins over a manufacturing fault in this valve on Sanden compressors. Its connector can also become brittle and corrode (especially without the engine undertray), or the wiring fails.
Check for the garage: Read the codes and N280 control current with VCDS or ODIS, measure its resistance (about 10 ohms) and check the connector and wiring before replacing parts. If the valve or compressor is replaced, the whole circuit must be flushed.
Cost cited in the source: N280 valve: a cheap part (about 30 dollars) where sold separately; new compressor with circuit flush: considerably moreA rough figure from the original database, not an up-to-date quote.

Applies if: Only with 75 mm hydraulic bushings.

Front knocking over bumps in hot weather caused by the guide link hydraulic bushingsSuspension and steering

Engine / equipment: A4 (B8), A5 (8T) and Q5 (8R) with 75 mm hydraulic bushings
Period mentioned: 2008–2014
Symptoms: Front knocking or rattling over bumps with the car warm and hot outside, especially when braking at the same time; in the cold it is not heard.
Possible cause described: Heat makes the front guide links' hydraulic bushings noisy (only the 75 mm ones). Audi describes it in bulletin 40 14 39 (February 2014) as a comfort issue that does not affect the car's handling.
Check for the garage: Note whether it only happens in hot weather and when braking over bumps. At the garage, have them check the front guide links' hydraulic bushings before replacing shock absorbers or ball joints.
Cost cited in the source: No verified estimate; ask the garage for a quote.A rough figure from the original database, not an up-to-date quote.