KNOWN FAULTS · BMW

BMW Serie 3 (E90/E91/E92/E93) 325i / 330i (6 cilindros) common problems.

2005–2012 · Petrol

Sources are not verified in real time and no entry confirms that your car is affected.

3 known faults with sources

BMW petrol electric water pump, leaks and VANOSCooling / leaks / VANOS

Engine / equipment: BMW petrol engines with an electric water pump: N52, N53, N54, N55, N20 and others from 2004–2016
Period mentioned: 2004–2016
Symptoms: Temperature warning and limited power with no prior warning (water pump); burning oil smell or smoke from leaks onto the exhaust or belt; rough idle and VANOS codes (2A82, 2A87).
Possible cause described: The water pump is electric and its electronics fail, often without warning, between 95,000 and 160,000 km. The valve cover and oil filter housing gaskets harden and leak; the latter can drip onto the belt. The VANOS solenoids get dirty and fail.
Check for the garage: Check the water pump and thermostat history, look for leaks at the valve cover and oil filter housing, and read VANOS codes.
Cost cited in the source: Water pump: approx. €550–1,100 fitted; oil filter housing gasket: €275–550; valve cover: €370–740 (converted from dollars)A rough figure from the original database, not an up-to-date quote.

Mileage cited in the database: 95,000–160,000 km. This is not a maintenance interval and does not predict a failure.

Corrupted FRM3 module (lights and windows)Electrical and electronic systems

Engine / equipment: FRM3 footwell module (lights, indicators and windows): 1 Series E81 to E88, 3 Series E90 to E93, X1 E84, Z4 E89, X5 E70, X6 E71 and E72 and MINI R55 to R61
Period mentioned: 2004–2015
Symptoms: After a flat battery, a battery change or disconnection, or a jump start: lights, indicators or windows stop working, side or dipped lights stay on and diagnostics cannot communicate with the module (for example code 00A3C1).
Possible cause described: The module's EEPROM gets corrupted by low or unstable voltage: a flat battery, jump starting, overcharging from a faulty alternator or loose terminals. It is a module software fault, not a wiring fault.
Check for the garage: Check the battery and charging and try communicating with ISTA. If the module does not respond, it can be repaired by rewriting its EEPROM (specialist services or programmers) instead of being replaced, then coded. Use a voltage maintainer when working on the car.
Cost cited in the source: Repair by a specialist service: from about €20–60 plus postage; new module with dealer coding: considerably moreA rough figure from the original database, not an up-to-date quote.

Applies if: Only if fitted with the automatic gearbox described in the record.

ZF 6HP mechatronic sleeve leak and harsh shiftsAutomatic gearbox

Engine / equipment: ZF 6-speed automatic 6HP19/21/26/28 (E53, E60/E61, E63/E64, E65/E66, E85, E90–E93)
Period mentioned: Approx. 2001–2013
Symptoms: Oil drips or dampness by the electrical connector on the side of the pan, a bump on the downshift just before stopping, harsh or flared shifts (especially 3rd-4th and 4th-5th under throttle) and a limp mode that clears after restarting.
Possible cause described: The sealing sleeve between the mechatronic unit and the wiring harness has O-rings that harden and let oil out. A BMW bulletin says to replace it only for a real leak, not mere dampness, and warns that fitting it wrongly damages the connector pins and forces a mechatronic replacement. With low fluid the gearbox loses pressure. Harsh shifts can also come from worn solenoids or valve body, not only the sleeve.
Check for the garage: At a garage: read the gearbox codes, check the fluid level with the official procedure (correct temperature and engine running) and look for a real leak at the sleeve and pan gasket. After a fluid or parts change, the garage should reset adaptations. If limp mode persists, check solenoids and valve body before replacing the gearbox.
Cost cited in the source: Sleeve and pan gasket: minor repair. If fluid is lost and the gearbox is damaged, in a US forum case BMW offered a remanufactured gearbox for about $2,800 without fitting.A rough figure from the original database, not an up-to-date quote.