KNOWN FAULTS · Dacia

Dacia Logan MCV (II) 1.5 dCi (K9K) common problems.

2013–2020 · Diesel

Sources are not verified in real time and no entry confirms that your car is affected.

4 known faults with sources

Applies if: Only Euro 6b 1.5 dCi (not the later Blue dCi), if the symptoms began after the 2024 update.

Judder and flat spots when accelerating on Euro 6b 1.5 dCi and 1.6 dCi engines after the 2024 emissions updateExhaust and emissions

Engine / equipment: Renault and Dacia Euro 6b 1.5 dCi (K9K) and 1.6 dCi (R9M)
Period mentioned: Cars that received the NOx-reduction update of early 2024
Symptoms: After a visit to the dealer, flat spots when accelerating and judder at steady speeds; sometimes higher diesel consumption. On the Mégane IV and Kadjar the engine may start and then stall.
Possible cause described: In early 2024 Renault and Dacia updated these engines to cut nitrogen oxides (NOx) further. According to an internal Renault technical note from June 2024, updated in February 2025 and reported by L'argus, the flat spots and judder are mainly due to the new strategy widening the periods when the NOx trap is cleaned (regenerated); to do so the engine injects more diesel, which also explains the higher consumption.
Check for the garage: Ask a Renault or Dacia dealer for the new injection ECU reprogramming for these symptoms (Dacia has offered it since May 2024 and Renault since January 2025). It is not a recall with a letter: you have to ask for it. First have them rule out other causes (particulate filter, boost pressure sensor).
Cost cited in the source: No verified estimate: the note does not say whether the reprogramming is free; ask the dealer.A rough figure from the original database, not an up-to-date quote.

Applies if: Weak points of this model from inspections, breakdown statistics and recalls; anything specific to one engine is stated in the sheet.

Three-cylinder timing chain, lights and campaigns on the Logan IIKnown weak points

Engine / equipment: Dacia Logan II and Logan MCV II (petrol, LPG and diesel)
Period mentioned: 2012–2020
Symptoms: On the three-cylinders (SCe 75, TCe 90 and 100), a chain that stretches early with a risk of serious failure and sometimes high oil consumption; failing dipped beams, tail lights and indicators, oil leaks, brake discs and suspension at the roadworthiness test; starter, ignition lock and battery.
Possible cause described: The naturally aspirated 1.2 16V is far more reliable. Many recalls (KBA): driver airbag (2012–2013 and 2018), track rod (17/9–4/12/2015), front-right caliper, steering-column mounting (23/11/2016–4/1/2018), trailer module, battery (11–14/6/2018) and bonnet latch (2/9/2020–15/1/2021).
Check for the garage: Listen to the chain when cold and measure oil consumption; check every campaign by VIN; check lights and leaks before the roadworthiness test.
Cost cited in the source: No verified estimate; ask the garage for a quote.A rough figure from the original database, not an up-to-date quote.

Applies if: Only cars built from 29/5 to 25/6/2020.

Recall: rear brake drum linings on the Logan MCV II (June 2020)Brakes

Engine / equipment: Second-generation Dacia Logan MCV built from 29/5 to 25/6/2020
Period mentioned: 2020
Symptoms: The rear brake drum linings are not the right ones and can impair the stability control (ESP).
Possible cause described: According to L'argus (January 2021), non-compliant linings were fitted in the rear brake drums of Logan MCVs built from 29/5 to 25/6/2020 (287 cars in France), the last ones before this generation ended. Dacia has written to owners by registered letter since December 2020.
Check for the garage: Ask Dacia by VIN whether your car is in the recall. The check takes about 20 minutes; if the linings have to be replaced, nearly two hours.
Cost cited in the source: Free under the recall.A rough figure from the original database, not an up-to-date quote.

Clogged particulate filter on the 1.5 dCiExhaust and emissions

Engine / equipment: 1.5 dCi (K9K) with particulate filter
Period mentioned: 2010 onwards
Symptoms: Particulate-filter or emissions warning, limp mode with loss of power and frequent regenerations.
Possible cause described: The filter clogs, especially on cars that mostly make short town trips and never complete a regeneration.
Check for the garage: Read the soot load with a diagnostic tool, run a forced regeneration at the garage and check the differential-pressure sensors and EGR. Make long road trips now and then.
Cost cited in the source: No verified estimate; from a regeneration to replacing the filter.A rough figure from the original database, not an up-to-date quote.