KNOWN FAULTS · Fiat
Fiat Grande Punto / Punto Evo / Punto 1.4 MultiAir / T-Jet common problems.
2005–2018 · Petrol
Sources are not verified in real time and no entry confirms that your car is affected.
2 known faults with sources
MultiAir actuator starved of oil pressureValvetrain (MultiAir actuator)
- Engine / equipment
- 1.4 MultiAir (naturally aspirated and turbo) and the 0.9 TwinAir, which uses the same system: Fiat 500, Punto, Tipo, 500X; Alfa MiTo and Giulietta; Jeep Renegade and Compass; Abarth
- Period mentioned
- 2009–2024
- Symptoms
- Hard or rough cold starts, hesitation, stalling and an engine light with P1523 (low oil pressure in the MultiAir system).
- Possible cause described
- The intake valves are operated by oil pressure through an electro-hydraulic block. Degraded oil, a low level or a dirty secondary filter starve the system of pressure, and over time the actuator fails internally.
- Check for the garage
- Change the oil and filter with the correct specification, inspect the MultiAir mesh filter and measure oil pressure before replacing the actuator.
- Cost cited in the source
- Oil change: the cheapest step and often enough; MultiAir actuator: approx. €650–1,400 (converted from dollars)A rough figure from the original database, not an up-to-date quote.
Sources from the original database
Go-Parts: P1523 on the Fiat 500XGo-Parts: P1523 on the Fiat 500FiatForum: 1.4 MultiAir cold-start problem
View full entryApplies if: Only with the Dualogic robotised gearbox (not a conventional automatic or a manual).
Dualogic robotised gearbox actuator and pumpGearbox
- Engine / equipment
- Dualogic robotised manual gearbox in the Fiat 500, Panda, Grande Punto / Punto Evo, Idea and Qubo, and Lancia Ypsilon and Musa
- Period mentioned
- 2003–2020
- Symptoms
- The car drops into neutral when braking or driving with a beep and “Check gearbox”, will not engage gears or is slow to engage reverse, slow and hesitant shifts, oil under the actuator and sometimes no start because it cannot select neutral. The pump's whirr is no longer heard when opening the door.
- Possible cause described
- An electric pump and an electro-hydraulic actuator operate the clutch and gears. The pump motor, the actuator piston seals (hydraulic fluid leaks) and the solenoid valves fail, and clutch wear also leads to the car sticking in neutral. A specialist warns that the same symptoms can come from pressure loss, the pump, the actuator or the wiring.
- Check for the garage
- Check the battery (with a low charge the pump may not run) and the hydraulic fluid reservoir level, look for leaks under the actuator and, at a garage, read codes and measure pressure and clutch wear before replacing the whole actuator. After any repair the system must be relearned.
- Cost cited in the source
- According to forum owners: a complete hydraulic actuator costs over £1,000 in parts, and about €3,500 if the dealer replaces the whole “robot”. Many faults are fixed with a clutch, pump or actuator repair.A rough figure from the original database, not an up-to-date quote.
Sources from the original database
FiatForum: the Dualogic faults threadFiatForum: Dualogic dropping into neutral on a 500FiatForum: Grande Punto Dualogic with no pump and no startFiatForum: Dualogic problemsFiat 500 Owners (forum): leak that returns after replacing the valveService4Service: Dualogic faults
View full entry