KNOWN FAULTS · Peugeot
Peugeot 308 (II) 1.6 THP common problems.
2013–2021 · Petrol
Sources are not verified in real time and no entry confirms that your car is affected.
3 known faults with sources
1.6 THP chain and tensionerValve timing
- Engine / equipment
- 1.6 THP / VTi (EP6, PSA-BMW “Prince” engine): Peugeot 207/208/308/3008/5008/508/RCZ, Citroën C4/C5/C4 Picasso, DS 3/4/5
- Period mentioned
- Approx. 2007–2018
- Symptoms
- Metallic rattle for several seconds after a cold start; engine light for timing deviation.
- Possible cause described
- The chain stretches and the tensioner is soft. Later units have a revised chain and tensioner, which reduce but do not eliminate the fault.
- Check for the garage
- Listen to a cold start and check whether the chain was replaced with the revised parts.
- Cost cited in the source
- Approx. €800–1,500 (converted from dollars)A rough figure from the original database, not an up-to-date quote.
Sources from the original database
View full entryApplies if: Only if fitted with the automatic gearbox described in the record.
EAT6/EAT8 jerking and torque converterAutomatic gearbox
- Engine / equipment
- Aisin EAT6 and EAT8 automatic gearboxes (308, 3008, 5008, 508, 2008, C4 Picasso, C5 Aircross, C4, DS 7, Grandland…)
- Period mentioned
- 2013–2026
- Symptoms
- Hesitation or a jolt between 1st and 2nd, torque converter shudder in traffic, harsh or delayed shifts and a gearbox fault warning, especially on 2017–2019 3008s.
- Possible cause described
- Torque converter wear or drift, valve deposits from degraded oil and software faults. Peugeot treats the oil as lifetime, but dirty or low oil causes harsh shifts.
- Check for the garage
- Check oil level and condition, update the gearbox software at the dealer and, after an oil change, record it with DiagBox and reset the adaptations.
- Cost cited in the source
- Oil change and update: the most common fix; torque converter or valve body: specialist garage repairA rough figure from the original database, not an up-to-date quote.
Sources from the original database
Service4Service: Peugeot EAT6 and EAT8 gearboxesService4Service: Citroën EAT6 and EAT8 gearboxesFrench Car Forum: EAT6 oil and adaptationAutodoc: common Peugeot 3008 problems
View full entryApplies if: Only cars built up to 20/6/2016.
Rear cross-member squeak on the Peugeot 308 IISuspension and steering
- Engine / equipment
- Peugeot 308 II built up to June 2016
- Period mentioned
- 2013–2016
- Symptoms
- Squeak from the rear axle on uneven roads or when the car's weight shifts in bends; it gets worse with mileage. A knock from the rear can also come from the silencer's rubber mount (cars built up to 9/10/2016).
- Possible cause described
- Rubbing between the pressed lower part and the rounded upper part of the rear cross-member. It affects cars built up to 10/12/2015 with a 25,000 Nm/rad anti-roll bar (the cross-member is replaced) and, according to a January 2017 note, those with a 30,000 Nm/rad bar built up to 20/6/2016 (some parts are replaced).
- Check for the garage
- Tell the garage when it squeaks (bumps, bends) and ask about the technical note on the cross-member; also have the silencer's rubber mount checked.
- Cost cited in the source
- No verified estimate; ask the garage for a quote.A rough figure from the original database, not an up-to-date quote.