KNOWN FAULTS · Dodge

Dodge Journey 2.4 / 3.6 common problems.

2008–2016 · Petrol

Sources are not verified in real time and no entry confirms that your car is affected.

2 known faults with sources

Applies if: Only cars built from 6/1/2016 to 2/8/2016 with the 4-speed automatic.

Wet carpet after driving through deep water because an underbody plug is missingBodywork

Engine / equipment: Journey 2.4 with the 4-speed automatic
Period mentioned: 2016
Symptoms: The floor carpet gets soaked after driving through deep puddles or flooded stretches, although no water gets in with normal rain.
Possible cause described: A rubber plug is missing from a hole in the underbody. FCA has it fitted (revised bulletin 23-052-16) on Journeys built from 6/1/2016 to 2/8/2016 with the 4-speed automatic.
Check for the garage: Dry the carpet to avoid smells and rust. At the garage, have them check whether the underbody plug is missing before looking for leaks in the doors or roof.
Cost cited in the source: No verified estimate; ask the garage for a quote.A rough figure from the original database, not an up-to-date quote.

Applies if: Only the 3.6 V6 Pentastar (from 2011); not the 2.4.

Leaking oil filter housing and cooler on the 3.6 PentastarEngine

Engine / equipment: 3.6 V6 Pentastar: Jeep Grand Cherokee, Wrangler and Gladiator, Chrysler Grand Voyager and 300C, Lancia Thema and Fiat Freemont
Period mentioned: 2011 onwards
Symptoms: Oil spots under the car, oil on the block below the housing (in the engine’s “V”), frequent top-ups and, in serious cases, a low oil-pressure warning; sometimes coolant leaks too.
Possible cause described: The plastic housing that holds the oil filter and cooler sits in the middle of the engine, exposed to heat: with heat cycles it warps and cracks. Overtightening the filter cap also damages it. Chrysler revised the design in 2014, but leaks still occur.
Check for the garage: Look for oil in the centre of the engine and under the car; do not overtighten the filter cap. The usual repair is replacing the whole assembly (aluminium versions exist), removing the intake manifolds, with new gaskets.
Cost cited in the source: No verified estimate; ask the garage for a quote.A rough figure from the original database, not an up-to-date quote.