Before you buy a used BMW X3 (E83).

Look out for: The 4x4, ABS and brake warning lights come on together while driving (often intermittently), a click or clunk under the car when switching the ignition off or on, and jerky acceleration in low gears.

Ask them to check: Scan every module with a diagnostic tool (transfer case codes) and measure the tread depth on all four tyres. The ABS and brake lights can have other causes, such as a wheel sensor or the ABS module: confirm before replacing parts. With the brake light on, also check the fluid and do not drive if the pedal feels abnormal.

Look out for: Loss of power, smoke or knocking, often with no prior warning: one of the flaps comes loose and drops into the cylinder.

Ask them to check: Check whether they have already been removed or replaced with blanking plugs and inspect the intake manifold.

Look out for: Usually none until it fails. A common early warning: oil seeping around the flap spindles on top of the engine. If a flap or its screw comes loose and enters a cylinder: sudden heavy knocking, loss of power, smoke and possible turbo damage as well.

Ask them to check: At a garage: confirm whether the manifold has swirl flaps (some versions do not), look for oil around the spindles and play in the flaps, and check the history for earlier replacement or removal. With any new metallic knocking, stop the engine and do not restart it.

Look out for: Rattling from the rear of the engine (gearbox side) on a cold start, getting worse over time. In extreme cases the engine cuts out while driving.

Ask them to check: Listen with the engine fully cold, ideally with a mechanic's stethoscope on the rear of the block.

Look out for: Loss of torque and pull below about 3,000 rpm, louder or unsteady idle, the engine bogs when the air conditioning is switched on and sometimes VANOS fault codes. On 1998–2000 M52TU engines, jolts or stalling on cold starts.

Ask them to check: Read the engine codes and, at a garage, compare actual and requested camshaft positions in live data. Rule out vacuum leaks and the CCV first, as they cause similar symptoms. On M52TU engines with cold jolts, the kit maker describes a test with the intake VANOS solenoid unplugged.

Look out for: Coolant loss without an obvious puddle, sweet smell, low-level warning, steam in the engine bay, heater stops warming and the temperature needle rises. Expansion tank failure is usually sudden; the water pump can fail with no visible leak.

Ask them to check: With the engine cold, check the level and look for cracks or dried coolant on the tank, radiator neck and thermostat housing. At a garage: pressure-test the system and inspect the pump. If the temperature rises, stop somewhere safe: a single overheat can warp the aluminium head. Never open the system hot.

Look out for: High oil consumption, bluish smoke, rough idle, whistling from a vacuum leak, engine light with lean-mixture codes and very strong suction when trying to remove the oil filler cap at idle.

Ask them to check: At a garage: smoke-test the intake to find leaks (CCV hoses, intake boots, DISA valve seal, valve cover gasket) and check whether the dipstick tube return is blocked. A cold-climate version of the system exists for cold regions.